Dusty Silver Blingy Glue-In Cuff Bracelet

Want to make this Design Idea? See products and other information below.

Supply List:

6 1/2 inches Leather Flat 10mm Bling - Black

1 Leather Cord Flat 10mm Glue-In Cuff - Rhodium Plated

Super New Glue

E6000 Glue .18 oz - Industrial Strength Adhesive Glue

Finished Length: 6 3/4 inches adjustable

Level of Difficulty: Beginner

Tools: Sharp Scissors or Leather Cutters, Nail File (optional), Tape or 24 Gauge Wire

Designer Tip: The bracelet blanks have rounded corners and the ends are at a slight angle. Using sharp scissors or flush cutters, trim one end of the leather to fit the bangle. Glue the end in with Super New Glue and use tape or wire to hold the leather in place while drying. Spread a small amount of E-6000 on the bracelet blank starting from the glued portion to about inch away from the other end. Press leather in place and trim other end to fit in bangle. Apply Super New Glue to the end of bangle and press leather in place, again using tape of wire to hold the leather while the glue is drying. A nail file can be used to smooth the rounded corners if desired. If the Super New Glue does not hold, allow it to dry completely and reapply. The rationale for using the E-6000 everywhere but the ends is that is it bonds with some elasticity and will allow the bangle to be opened and closed without cracking. Super New Glue tends to be a bit more brittle when it is dry, and that is why we don't recommend it for the bendable part of the cuff, but will hold the ends strongly.

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.