Tree of Serenity Claycult Necklace
Want to make this Design Idea? See products and other information below.
Designer Tip: Cut both cords in half and double. Thread all four pieces through the pendant and center; fold up and tie all 8 strands in an overhand knot. Separate the strands into 2 2mm and 2 1mm per side. Working on one side, tie an overhand knot in one strand about inch from the center knot, thread on a Claycult bead, and knot on the other side. Repeat on the other side, altering the type and position of the bead. Repeat with additional beads and strands, working from side to side to make sure the distribution of beads is balanced. Note that, if the beads do not slide easily over the 2mm cord, you can use a bead reamer to slightly enlarge the hole. Finish the necklace per video: Trim 3 of the 4 strands on one side to the desired length, add the 8mm jump ring to the untrimmed strand, fold over, and use a section of the unused leather to form a coil knot at the top. Add the 6mm jump ring to the clasp and repeat on other side. Trim all leather ends and glue.Helpful Video Tutorial:Click here to Watch Using a coil knot to finish a multistrand necklace
To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.