Shopping Cart

Home > Ideas > Body Jewelry Design Ideas > Rock On Thong Bracelet

Rock On Thong Bracelet

Rock On Thong Bracelet

Want to make this Design Idea? See products and other information below.

Supply List:

3 TierraCast Link Rock and Roll 3 Hole Bar - Antique Silver

7 inches Chain 7mm Etched Cable - Antique Silver

14 inches Chain 3mm Etched Cable - Antique Silver

3 Jump Ring 15mm 14g - Antique Silver

2 Jump Ring 10mm 14g - Antique Silver

1 TierraCast Clasp Lobster 15mm - Antique Silver

1 Eye Pin 2 inch 20g - Antique Silver

Finished Length: 7 1/2 inches

Time To Make: Under one hour

Level of Difficulty: Intermediate

Tools: Looping Pliers, Chain Nose Pliers, Flat Nose Pliers, Flush Cutters

Designer Tip: Cut the 7mm chain into 2 7-link segments. Thread the eye pin through the top loop of a 3-hole bar and form a simple loop at the top. Connect each of the two 7mm chain segments to each loop of the eye pin. Cut the 3mm chain into 2 12-link (3 inches), 2 10-link (3 inches) segments, and 2 3 inch segments. Open a 15mm jump ring and string on the bottom loop of the bar with the 7mm chain at the top, a 10-link chain segment, another bar, and another 10-link chain segment; close. Repeat with the 12-link chain segments, adding the two 3 inch segments at the bottom of the ring to form a finger ring. Connect the three chain segments on both sides using the 10mm jump rings, adding the clasp to the ring on one side.

Helpful Video Tutorial: Click here to WatchJump Rings 101 Basic Techniques for Jewelry Making and Click here to Watch Simple Looping Techniques for Jewelry Making

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.