Love Lavender Waxed Cord Wrapped Round Leather Bracelet

Want to make this Design Idea? See products and other information below.

Supply List:

7 inches Arizona Leather Flat 10mm - Violet

2 yards Waxed Jewelry Cord Round - Silver

1 Leather Clasp Magnetic Rectangle 10mm - Antique Silver

1 Leather Slider 10mm Frame Square - Antique Silver

6 Rosewood Bead Rice Beads 5x10mm

18 Cultured Sea Glass Bead Tube 9x4mm - Periwinkle

Super New Glue

Finished Length: 7 1/2 inches

Level of Difficulty: Intermediate

Tools: Scissors, leather cutter, lighter, darning or big eye needle

Designer Tip: Cut waxed cord in half. Lay one piece of the waxed cord across leather on the back of the cord and wrap 4 times around both leather and tail. Pull tail slightly so it lays near the top of the leather. Add a bead and wrap around leather so bead lays on the top of the leather. Follow this with a wrap with no bead. Continue wrapping and adding sea glass tubes and rosewood rice beads until you are 3/8 inches away from the center. Wrap cord around the leather 4 times. Use a darning needle to run the cord through the wraps on the back. Add slide and finish second half of the bracelet. Check fit before gluing clasp on; this clasp will add about 1/2 inches to the length of the bracelet. Adjust wraps and trim leather if necessary before gluing clasp on. Trim ends of cord, both near the clasp and the center slide; burn/glue ends.

Helpful Video Tutorial:Click here to Watch How to Make Jewelry Using Waxed Beading Cord and Click here to Watch How to Size & Glue Leather Bracelets

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.