Fruit on the Vine Macrame Waxed Cord Knotted Bracelet

Want to make this Design Idea? See products and other information below.

Supply List:

4 feet Leather Round 2mm - Metallic Olive

1 foot Waxed Jewelry Cord Round - Ecru

1 Jackfruit (Nangka) Wood Bead Puffed Oval 14x23x8mm

12 Jackfruit (Nangka) Wood Bead Round 6mm

Super New Glue

Finished Length: 7 1/2 inches adjustable

Level of Difficulty: Intermediate

Tools: Knotty Do-It-All Board (or clipboard or tape), Sharp Scissors, Lighter

Designer Tip: Cut 5 inches of leather. Attach waxed cord to leather using a coil knot, Trim and burn ends of cord and trim end of leather to about 1/8 inches. Clip leather near knot into a clip on the Knotty Do-It-All Board or use a clipboard or tape to secure leather tail. Place a drop of Super New Glue onto the knot. Fold remaining leather in half and begin knotting around knot with a basic macram knot. Repeat with 3 more knots until waxed cord knot and tail of leather are covered. String a bead onto the waxed cord; knot around bead with 2 knots. Repeat until about 6 inches of beads are added. Before last set of knots, place a drop of glue on cord and knot around cord; repeat 3 times. Trim tail of waxed cord and melt end. Coil bracelet around and knot 6 times around the tail this will produce the slider closure. Trim ends of leather and carefully glue. Determine maximum opening needed to put bracelet on and tie knot in tail at this point; trim end. Close bracelet by pulling on tail.

Helpful Video Tutorial:Click here to Watch How to Make a Beaded Bracelet with a Macrame Slider Clasp

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.