Cutout Coil Flat Leather Bracelet

Want to make this Design Idea? See products and other information below.

Supply List:

8 inches Leather Flat 20mm - Dark Brown

22 inches Leather Round 2mm - Natural

2 yards Leather Round 1mm - Natural

1 Bracelet Bar - Slate Cutout Antique Silver

1 Leather Clasp 20mm Push In - Antique Silver

Super New Glue

Finished Length: 8 1/2 inches

Level of Difficulty: Intermediate

Tools: Leather Cutter or Sharp Scissors

Designer Tip: SEE VIDEO LINKS BELOW. Cut the 2mm leather in half. Double one piece over and tie a Larks Head knot around the end of the bar; repeat on other side of bar. Center bar on leather. Use the 1mm leather to tie three sets of coil knots on either side of the bar around the 20mm and 2mm leather but do not glue back of knot yet. Glue the 20mm leather into the larger side of the clasp, noting that this part of the clasp is open: it may be preferable to put the glue on the leather rather than into the clasp to ensure the latch assembly does not get glued closed. Check the size and trim leather if needed before gluing second side. Center bar and place a drop of glue on the 2mm leather just on the other side of the Larks Head knot and slide the coil knot over it to keep the bar centered. Close the clasp and trim the 2mm leather flush with the clasp. Place a drop of glue on the 2mm leather right next to the clasp and slide the last coil knot flush with the clasp. Repeat on other side. Adjust middle coil knot. Trim and glue the tails of the coil knots on the inside of the bracelet.

Helpful Video Tutorial:Click here to Watch How to Make a Coil Knot and Click here to Watch How to Tie A Lark's Head Knot For Jewelry Making Video Tutorial and Click here to Watch Designing Elements for Leather or Cord Bracelets

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.