Walk in the Woods Bracelet
You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.
1 Clay River Porcelain Leaves 10mm Flat Bracelet Blank - Green Tea 18 inches 3mm Flat Leather Cord - Chocolate Brown 27 inches 1.5mm Round Indian Leather Cord - Metallic Ocean Green 12 inches 1mm Round Indian Leather Cord - Dark Brown1 10mm Flower Flat Leather Cord Magnetic Clasp - Antique Silver Supertite Glue - 3g bottle Finished Length:7 1/2 inchesLevel of Difficulty:IntermediateTools:Flush Cutters
Designer Tip: Cut the 3mm leather into 4 equal pieces; cut the 1.5mm leather into 6 equal pieces. Position hald of the leather strands as shown, with a 1.5mm length of leather between and outside the 3mm leather pieces. Insert all strands through the slot at one end of the bracelet bar from front to back. Fold over about 5/8 inch and secure the loop with glue (Note: You may need to tape or hold the loop for a few minutes to secure all the strands. Form a coil knot around the loop, positioning it so the edge of the knot is flush with the cut leather ends on the back. Repeat on the other side. Check the size and trim the leather ends if needed before gluing the leather ends into the clasp.
Helpful Video Tutorial:Click here to Watch How to Size and Glue Leather BraceletsandClick Here to Watch How to Tie a Coil Knot
To add items to your cart, fill in the desired quantity then click "Add To Cart" at the top or bottom of the page to add all selected items to your shopping cart.