Designer Tip: Cut the 3mm leather in half.  Center the 10mm leather between the two pieces of 3mm leather and add the 20mm slide over all three strands.  Add a 10mm slider onto the 10mm leather on either side of the 20mm slider.  Glue one end of the leather strands into the clasp (Note – this may require trimming the ends of the 3mm leather at a slight angle to help them fit into the clasp).  The outside strands of leather may need to be slightly longer than the inside  in order to fit around the 10mm sliders.  Check the size and trim the leather if needed to ensure a good fit before gluing the other ends of leather into the clasp.

Helpful Video Tutorial:Click here to Watch How to Size and Glue Leather Bracelets

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.