Simply Knotted Necklace
You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.
Designer Tip: Designer Tip: Cut the cord into three equal pieces. It is easier to work with this piece if you start in the middle and then work one side and then the other. To start, tie an overhand knot in the middle of the three cords. String a 20mm coin onto one of the cords, position the other two cords on either side of the coin, and then tie an overhand knot with all three cords. Thread a TierraCast Baule bead over all three strands and tie another overhand knot. Keep adding the rice bead, a 12mm Amazonite, and an 8mm Amazonite with a knot between each, stringing one strand of cord through the bead and brining the additional strands to the side. For the next set of beads, leave 1.5-2 inches of cord and tie another overhand knot. Add the flower bead, the TierraCast tube bead, and an 8mm Amazonite bead. Continue alternating sets of 5 beads and 3 beads. Note that all three strands of cord will pass through the Tierracast beads. When you reach one end, start working on the other side of the cord. To finish, add two 4mm jump rings to the clasp. Tie the 10mm jump ring onto one end of the necklace and the 4mm jump rings to the other end using an overhand knot. Secure the knots with a small amount of glue. Trim the ends and melt them using the lighter. Note that this can be worn as a sinlge strand or double strand necklace, or even as a 5-wrap bracelet.