Rafa's Ring Necklace

Want to make this Design Idea?

You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.

Supply List:

2 feet 2mm Round Leather Cord - Natural Pacific

1 Graywood Bead O-ring 28x5mm

2 Graywood Bead Round 8mm Large Hole

1 5mm Mini Target Square Flat Leather Cord Slider - Antique Silver

3 Jump Ring 10mm 14g - Antique Silver JR10-AS

Finished Length: 20 inches adjustble

Level of Difficulty: Beginner

Time to Finish: Under 1 Hour

Tools: Flush Cutters, Chain Nose Pliers, Navy Sharpie (optional)

Designer Tip: Fold the leather in half and insert both ends through an 8mm bead in the same direction to form a inch loop. NOTE: this will be a tight fit and so to form a needle at one end of the leather, flatten with flat nose pliers and use flush cutters to cut the leather at an angle to form a point. Once the needle is coming through the other side, it may also be necessary to use chain nose pliers to pull the second strand of leather through the bead. Add the slide to both strands above the Graywood bead. To form a sliding closure, bring the two strands through the second Graywood bead from opposite directions. Form an overhand knot near the end of each leather strand. Use the three 10mm jump rings to add the Graywood O-ring to the loop. If the leather has been scraped in the process of pulling it through the wood beads, use a navy blue Sharpie to cover the scrapes.

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.