Pop Wrap Bracelet
You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.
21 inches 5mm Flat Pop Leather – Picasso1 5mm Rounded Flat Leather Cord Magnetic Clasp - Antique Brass 1 Claycult 6mm Round Ceramic Bead – Turquoise 1 TierraCast Charm Open Heart - Gold Plate 1 Cultured Sea Glass Bead Round 10mm - Royal Blue2 Head Pin 2 inch 20g (20) - Satin Hamilton Gold 1 Jump Ring 4mm 21g (100) - Satin Hamilton Gold1 Jump Ring 8mm 18g (30) - Satin Hamilton Gold 1 TierraCast Rivet Eyelet 3.7mm - Antique GoldSupertite Glue - 3g bottle Finished Length:21 inchesLevel of Difficulty:BeginnerTools:Flush Cutters, Leather Punch, Eyelet Setter, Hammer, Bench Block, Looping Pliers, Chain Nose Pliers
Designer Tip: Make a mark on the center of the the back of the leather. Use the smallest setting (5/64 inch), punch a hole at the mark*. Set the eyelet in the hole. String a bead on each head pin and form a simple loop at the top. Attach the charm to a 4mm jump ring. Open the 8mm jump ring; string on the charm and the dangles, thread through the eyelet, and close. Check the size and trim the ends of the leather as needed to ensure a good fit for a triple wrap bracelet. Use the glue to secure the ends of the leather in the clasp.
*Note: sometimes it is difficult to punch 5mm leather without going over the edge, so test the punch first. If you have a problem, use a nail setter: position the nail setter over the mark and hammer to make a hole. Stretch the hole as needed and then add the eyelet.
Helpful Video Tutorial:Click here to Watch How to Size and Glue Leather BraceletsandClick Here to Watch Leather Punching and Riveting Basics
To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.