Oak Cluster Necklace
You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.
Designer Tip: Slightly flatten the bracelet bar and use a metal punch or drill to punch three holes on one side of the bar as shown. Thread all but one of the Jasper and Bayong beads onto a headpin and form a simple loop at the top of each. Attach one large link of chain onto the left-hand hole with a 6mm jump ring and add a Bayong dangle to the chain link. Add a Jasper and Bayong dangle to the jump ring. Attach 4 large links of chain to the middle hole with a 6mm jump ring. Add 5 Bayong dangles and 3 Jasper dangles as desired to achieve a cascade effect. Attach 2 large links of chain to the right-hand hole and add 3 Bayong dangles and a Jasper dangle as desired. Cut 2 14-inch segments of leather. Thread one segment through the large end hole of the bracelet bar and center; secure with a 4-wrap coil knot. Repeat on other side. Attach the remaining chain to a 6mm jump ring and a clasp to the other 6mm jump ring. Finish the necklace by looping one end of the leather through a 6mm jump ring, folding the end over parallel to the two strands of leather, and securing with a coil knot. Repeat on other side. Trim the leather ends and secure with a small amount of glue. Add a Bayong and a Jasper bead to the last head pin; form a simple loop at the top and attach to the end of the extender chain.