Missing Piece Cork Bracelets

Want to make this Design Idea? See products and other information below.

Supply List:

Men's:

• 8 inches Portuguese Regaliz Cork Cord 10mm Oval - Malllard
• 1 Regaliz Clasp Magnetic with Safety - Antique Silver
• 1 Regaliz Slide 3-Hole - Antique Silver
• Super New Glue

Women's:

• 7 inches Portuguese Cork Cord 5mm Flat - Mallard
• 1 Leather Clasp Magnetic Rounded 5mm - Antique Silver
• 3 TierraCast Snap Rivets 4mm Bag of 10 - Silver Plate
• Super New Glue

Finished Length: Men's 8 inches; Women's 7 inches

Level of Difficulty: Beginner

Tools: Leather Cutter, Leather Punch, 4mm Rivet Setter, Bench Block, Hammer

Designer Tip: For Men's Bracelet, add the slide to the cork and glue one end into the leather. Check size and trim leather if needed to ensure a good fit. For Women's Bracelet, make a mark in the middle of the leather and 2 more marks 3/8 inch on either side. Use the leather punch to punch a holes at each mark using the 5/64 inch (smallest) setting of the leather punch. Use the bench block, hammer, and rivet setter to add a rivet to each hole. Check size and trim leather on both sides if necessary to ensure a good fit before gluing the leather into the clasp.

Helpful Video Tutorial:Click here to Watch Leather Punching & Riveting Basics for Making Leather Bracelets

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.