Gypsy Disk Necklace
You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.
Designer Tip: Designer Tip: Cut the chain into ten 1.5 inch segments. Add 2 segments to each of the five 4mm jump rings. Add all the 4mm jump rings to the 10mm jump ring. Using the wire, wrap three times through the center hole and around the disk; form a wrapped loop with both wire tails at the bottom. Thread the eye pin through the Claycult bead and form a simple loop at the top. Attach the Claycult link to the 10mm jump ring on one side and the loop at the bottom of the disk on the other side. Thread the leather through the center hole of the disk; center and tie an overhand knot to secure. Finish the ends using a slider knot.