Floating Bubbles Swarovski Designer Component Necklace

Want to make this Design Idea?

You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.

Supply List:

1 Swarovski 6730 18mm Radiolarian Pendant - Crystal Silver Night

1 20mm Bubble Pendant / Link - Antique Silver

2 TierraCast Cord End Cap Taj 2mm - Antique Silver

32 inches 1mm Round Leather Cord - Metallic Gunmetal

9 Jump Ring 6mm 21g - Antique Silver

4 Jump Ring 4mm 21g - Antique Silver

10 Jump Ring 3mm 22g - Antique Silver

1 Clasp Lobster 12mm - Antique Silver

Super New Glue

Finished Length: 16 1/2 inches

Time To Finish: Under 2 Hours

Level of Difficulty: Beginner

Tools: Chain Nose Pliers, Flat Nose Pliers, Flush Cutters

Helpful Video Tutorial: Click to Watch Jump Rings 101 Basic Techniques for Jewelry Making

Designer Tip: Attach the Swarovski drop to the bubble focal using two 6mm jump rings. Attach three 6mm jump rings to each of two openings in the other side of the bubble focal as shown. Cut the leather in half and glue one end into a TC end cap. Thread jump rings on the leather as follows: five 3mm jump rings, a 4mm jump ring, three 6mm jump rings already attached to the bubble focal, a 4mm jump ring, the other three 6mm jump rings attached to the focal, a 4mm jump ring, and the other five 3mm jump rings. Glue the other end of the leather into the end cap. Attach the clasp to one end cap using a 4mm jump ring; attach the 6mm jump ring to the other end cap.