Elephant Walk Mens Leather Bracelet

Want to make this Design Idea? See products and other information below.

Supply List:

7 inches Leather 3mm Braided Round - Black

7 inches Suede Flat 3mm - Grey

24 inches Leather Round 2mm - Dark Grey

48 inches Waxed Jewelry Cord Round - Bronze

1 TierraCast Bead Elephant Large Hole - Antique Brass

18-20 Graywood Bead Cube 6mm

3 feet Wire - 22 Gauge - Vintage Bronze

Super New Glue

Finished Length: 8 1/2 inches

Level of Difficulty: Intermediate

Tools: Scissors, lighter

Designer Tip
:1. Knot approximately 5 inches of beads on 2' of the waxed cord: leave a 1 inch tail on each side
2. Center elephant bead on braided cord and form a wire coil on either side
3. Cut 16 inches of the 2mm leather cord. Tie 3-4 overhand knots towards the middle of the cord; form wire coils between knots at random intervals.
4. Match the ends of the suede, braided leather, and waxed cord. Leave about 3 inches of the 2mm leather cord extending beyond the other strands. Form a coiled knot with about 1' of the waxed cord. Trim and burn/glue ends, leaving the 2mm leather long. Repeat on other side.
5. Overlap the 2mm leather ends and tie a basic macram slide knot around the ends. Tie knots at the end of cord and trim. To open the bracelet, pull the ends of the bracelet apart; to tighten, pull the 2mm leather cord ends apart.

Helpful Video Tutorial:Click here to Watch How to Make a Beaded Bracelet with a Macrame Slider Clasp and Click here to Watch Wirework 101 Basics Techniques for Jewelry Making

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.