Bolted Anchor Flat Leather Bracelet

Want to make this Design Idea? See products and other information below.

Supply List:

18 inches Leather Flat 5mm - Tan / Black

1 Cord Flat Clasp 5mm Hook Anchor - Antique Silver

1 Leather Slider Flat 10mm Dot Triple - Antique Silver

2 TierraCast Snap Rivets 4mm Bag of 10 - Silver Plate

Finished Length: 8 1/2 inches

Level of Difficulty: Beginner

Tools: Leather Punch, Hammer, 4mm Rivet Setter, 1/32" Nail Setter, Bench Block, Leather Cutter or Sharp Scissors

Designer Tip: SEE VIDEO LINKS BELOW. Fold the leather in half and add the slide to form a inch loop at the top. Check the size by inserting the leather through the two rings at the bottom of the clasp and folding it over about inch; trim the leather if needed to ensure a good fit. Mark both ends of the leather 1/8 and 1 from the end; punch a hole using the smallest setting on the leather punch or a 1/32" nail setter. Insert the leather back through the rings of the clasp; place and set the rivets.

Helpful Video Tutorial:Click here to Watch How to Rivet an Urban Raku Center Hole Focal and Click here to Watch Design Elements for Leather or Cord Bracelets

To add items to your cart, fill in the desired quantity at the top or bottom of the page to add all selected items to your shopping cart.