Bermuda Dream Swarovski Designer Component Necklace

Want to make this Design Idea?

You can quickly add all the required items by clicking the SELECT ALL button below, ENTERING required quantities like # of INCHES of Leather, UNCHECKING any unwanted items. Then go to bottom of page and click ADD TO CART.

Supply List:

1 Swarovski 6730 34mm Radiolarian Pendant - Crystal Bermuda Blue

1 46mm Open Bubble Pendant / Link - Satin Hamilton Gold

32 inches 1mm Round Leather Cord - Purple

14 inches Chain Rolo 2mm - Satin Hamilton Gold

6 inches Chain Rolo Petite Double 2mm - Satin Hamilton Gold

3 Jump Ring 3mm 22g - Satin Hamilton Gold

3 Jump Ring 4mm 21g - Satin Hamilton Gold

1 Jump Ring 6mm 21g - Satin Hamilton Gold

1 Jump Ring 8mm 18g - Satin Hamilton Gold

1 inch Wire - 24 Gauge - Non-Tarnish Gold

2 TierraCast Cord End Cap Pagoda 2mm - Gold Plated

1 TierraCast Clasp Lobster 12mm - Gold Plated

Super New Glue

Finished Length: 16 inches

Time To Finish: Under 2 Hours

Level of Difficulty: Intermediate

Tools: Chain Nose Pliers, Flat Nose Pliers, Flush Cutters

Helpful Video Tutorial: Click to Watch Jump Rings 101 Basic Techniques for Jewelry Making and How to Tie a Larks head Knot for Jewelry Making

Designer Tip: Attach the Swarovski focal to the bubble focal as shown. Cut 4 lengths of the 2mm double rolo chain approximately 1 inch in length and two lengths approximately inch on length (These do not have to be exact). Open a 3mm jump ring and add two 1 inch chain sections; close. Repeat with the two other 1 inch and inch chain sections. Add the jump rings with the two longer chain sections and the one with the shorter chain sections to the bubble focal as shown using 4mm jump rings. Cut and attach a 4-link section to the top loop on the other side of the Swarovski focal using another 4mm jump ring. Cut the leather in half. Fold each section in half and attach to the top link of each side of the bubble focal. Cut the rest of the 2mm chain in half and attach a section to the using 4mm jump rings in the middle of each Larks Head knot. Trim each side of the leather to 7 inches and glue into a Tierracast end cap. Trim the chain about 1/8 inch shorter than the leather. Cut the wire in half. Thread one section of wire through the chain and fold in half. Trim to 1/8 inch and glue into the end cap. Repeat on the other side. Attach the clasp to one end cap using a 4mm jump ring; attach the 6mm jump ring to the other end cap. Apply a small amount of glue to the Larks Head knots if needed to hold in place.